Taylor Guitar Bridge Reglue 重新黏合木結他琴碼
近年頻頻出現在Taylor結他上的問題就是琴碼翹起,本地長期潮濕的環境下,此情況也不乏出現在其他品牌結他上。
徵狀可以透過觀察結他琴碼邊角位置有沒有開始翹起,取出一張紙放進 (攝入) 琴碼底部,如果能夠通過,則代表膠水黏不住,開始分離。
邊角輕輕翹起屬輕微情況,還未有迫切性馬上要維修。假如情況日趨嚴重,則需要進行維修。
檢查這支Taylor結他時,發現其琴碼很嚴重地翹了起來
We found the bridge of this Taylor guitar is lift severely.
從側面也能看到其翹起程度,接近一半的黏合面積也拉了出來
You can see how serious from side, almost half of bridge are lift.
最嚴重的位置翹起差不多4mm,不能再拖延維修了
The most serious area is about 4mm lifting height, NO hesitation to have reglue work.
品絲表面也被污衊鏽積覆蓋著
The condition of fretwire was in very bad, covered by dirt and rust.
品絲變得暗淡無光澤
The frewire was no more shine anymore.
弦鈕則需要一般的清潔護理
The machine head needed a clean and polishing work.
因這個維修時間比較迫切,過程中沒有拍攝,修復完成馬上交給客戶,以下兩張成果相片由客戶提供。
修過程先要用 Bridge Iron 加熱熨斗 加熱將琴碼的的膠水軟化,並將琴碼從結他上取出。然後把琴碼底部膠水完成清理走並打磨至平整,使用 #150 Diamond Levelers 金鋼砂平面打磨塊 能夠加快平整工作。
自行調配的hide glue取代titebond即用木膠水,雖然預備時間長,但黏合力更加強及穩定性高。
配合Stewmac專用的 Bridge Caul 琴碼固定墊 及夾具進行加固。
完成後,為結他進行清潔,換上新弦及setup
Because it was a urgent call, we didn't take any photos during repairing, below two photos were given by the customers.
We use Iron heater to soften the glue and remove it from the guitar firstly. Then remove the old glue residue and level the bridge bottom.
Hide glue was used for this project because it provides a more stronger adhesiveness and much much stability.
After the bridge is re-glued, we clean the guitar up, change a new set of strings, bridge pins and set it up!
弦木舍結他工作室提供電、木結他setup、維修、變換零件及各樣升級服務,歡迎電郵info@tarhouseguitar.com查詢
Tar House provides electric, acoustic, classical guitar setup, repair, parts replacement and upgrade service, please inquire at info@tarhouseguitar.com